Cost Specialty work
What Specialty Wolf Repairs Cost on Mercer Island
One page for each kind of specialty visit we make on the island. Each prints only the bands that apply to that work, and every job is priced in writing before a part is ordered.
One flat $89 visit pays for the trip out and the whole diagnosis, and the $89 is deducted from the repair if you approve it.
- 01 Cost of Wolf Steam Oven Repair Three published bands for the steam oven's electrical and door parts; the water system is priced once the fault is found. Three published bands other parts quoted after diagnosis
- 02 Cost of Wolf Dual Fuel Range Repair Four published bands cover the gas top and the oven's sensor and control; elements and the over-temperature protection are priced once measured. Four published bands other parts quoted after diagnosis
- 03 Cost of Wolf Warming or Microwave Drawer Repair One published band covers the drawers' controls; elements, mechanisms and microwave parts are priced once the fault is found. One published band other parts quoted after diagnosis
- 04 The $89 Service Call on Mercer Island One flat fee for the trip and the whole diagnosis, anywhere on the island, taken off the repair once you approve it. $89 visit
Some specialty work has no published band — a steam oven's water system, a drawer's opening mechanism, parts that are ordered to the serial. Those are quoted after the diagnosis and never guessed at over the phone. Call Mercer Island Wolf Appliance Repair on (206) 785-2960 and we will say which kind your fault is.
ReviewsMercer Island, WA
In their words
5.0 / 5 · 1,107 reviews
The simmer setting kept dropping out on the back burner. Turned out to be a worn valve rather than the igniter everyone else blamed. Explained clearly, priced before the work, no surprises after.
Cordelia N. · North End · Jun 2026
Wall oven behind a cabinet return that nobody wanted to open. He pulled the trim, tested the thermostat properly, and put the millwork back so you cannot tell it came off.
Gideon R. · The Lakes · Apr 2026
Blower stuck on one speed and the light bank kept flickering. Two separate faults, both explained, both fixed in the visit. He also pointed out a duct problem that was not his to fix.
Jonathan B. · North End · Jan 2026